Bolt Circle

This will create the NC code for the coordinates of the bolt circle and insert them into the editor at the cursor position.

Start Angle – The first hole will be placed here.

End or Incremental Angle – If the 'Use Incremental From Start' box is checked then this represents the angle between each hole, otherwise, this is the angle of the last hole.

Total Number of Holes – Including the first and last holes.

Output Angles – Check this if you want to output angle positions.

Output X,Y – Check this if you want to output X and Y coordinates.

Radius – this is used only when Output X,Y is checked.

_________________________________________________________________